HTp213 - Spinning rod holder with the glue-on kit for installation on the PVC boat (Ht213 + FMp224)
Technical Details:
The kit includes an Ht213 spinning rod holder and an FMp224 mounting system for inflatable PVC cylinders. The design of the holder consists of a body, a retainer, an end limiter, a hole for attaching a safety leash carabiner, a tilt 27.7° splines joint, completed with 7.5° splines Dp230 adapter washers and fasteners (an M6*50 DIN 931 screw and an M6 DIN 934 nut with a hex knob) and a male adapter shaped as a 12 pointed star for fixing in the mount. The FMp224 kit includes a pad (110 x 110 mm) and an Fs219 mount, fastened together with four M6*20 DIN 912 screws and M6 DIN 985 nuts. The system can be glued to the PVC surface using two-component polyurethane adhesive (not included). The main parts are made of fiberglass-reinforced polyamide. The pad is covered with PVC. Fasteners — of A2 (AISI 304) stainless steel (except for the M6 DIN 934 brass nut).
| Category: | Borika Fasten |
|---|
Tips on using & installation:
- To install the mounting kit you should glue it to the surface of the PVC cylinder using two-component polyurethane adhesive according to the step-by-step guide. It can be used as intended the day after installation.
- Separating the splines you can supplement the holder with BORIKA FASTen® extenders from 10 to 30 cm with the same splines, allowing the accessory to be mounted overboard or above the installation surface, which is especially convenient, for example, for using spinning rods with long handles.
- The mounting system included in the kit is designed for medium loads and suits for fixing any BORIKA FASTen® accessories: fish finder plates and transducer arm mounts, action camera monopods, navigation lights, rigging, awnings, trolling stands, etc. With conversion adapters, which are presented in the BORIKA FASTen® catalog, you can fix in the mount some accessories and devices from other brands ( SCOTTY®, RAM®, RAILBLAZA®, YakAttack®, carp fishing tackles, etc.).
- Please note that we recommend gluing FMp224 systems with the distance between the centers of the mounts in multiples of 305 mm. This will allow them to be used to fix accessories with paired adapters such as round rail, boat table or support stand.
- To prolong the service life of the product, after using it in sea water, rinse it with plenty of fresh water.
