Ht213 - Universal spinning rod holder
Technical Details:
Designed for fixing spinning rods with different types of reels and handle diameter of up to 38 mm during fishing and transportation. The design comprises the holder body, the retainer, an end limiter, a male adapter shaped as a 12 pointed star and the tilt 27.7° spline joint complete with 7.5° spline adapter washers and a spring. The tilt position is fixed with the M6*50 DIN 931 bolt, the M6 DIN 934 nut and the hex plastic knob. There is a hole for attaching a safety leash carabiner on the holder body. The main parts are made of fiberglass-reinforced polyamide. Fasteners and spring — of A2 (AISI 304) stainless steel (except for the M6 DIN 934 brass nut).
| Category: | Borika Fasten |
|---|
Product description:
- The Ht213 is a universal model that is suitable for fixing spinning rods with different types of reels: inertia, electric, baitcasting (multiplier) and fixed-spool. Its functionality and ergonomics will be appreciated by the owners of all types of vessel: inflatable motor and rowing boats, fishing and inflatable kayaks, belly boats (float tubes), RIBs, motorboats, SUP boards and others.
- The retainer securely fixes the handle, protecting the spinning rod from falling into the water and allowing for a quick release if necessary. There is an end stopper at the rear of the holder, which serves as a limiter and prevents axial rotation of rods with the end cruciform slot. It also can be taken off when fixing long-handled spinning rods.
- At the bottom of the holder there is a hole for attaching a safety leash carabiner.
- The spline tilt joint allows installation of the spinning rod both parallel and perpendicular to the water surface, and provides complete control over the fishing process. The joint is also equipped with 7.5° splines adapter washers for more precise tilt adjustments and the spring for quick spline spreading.
- The holder adapter is compatible with all BORIKA FASTen® mounting systems and allows the accessory to be fully rotated in 30° increments.
- It is supplied both separately and in mounting kits for installation on various types of surfaces: on a hard deck or side or inflatable PVC cylinders, on T-Tracks, on tubes and rails with a diameter of 22, 25, 30 or 32 mm, etc.
- The fiberglass-reinforced polyamide, of which the main parts are made, protects the handle from damage (compared to metal holders).
Materials: fiberglass reinforced polyamide, A2 (AISI 304) stainless steel, brass.
In the package: an Ht213 spinning rod holder.
Tips on using & installation:
- For installation on the vessel any mounting system is required. Pay attention that if you plan to use this holder when trolling, you should choose mounting systems designed for increased loads.
- The main splines of the joint are 27.7°, so the device can be supplemented with BORIKA FASTen® extenders, the length of which does not exceed 30 cm. This is relevant, for example, for spinning rods with long handles, the tilt adjustments of which are prevented by the side of the boat.
- You can complement the assembly with transition washers, which allows for installing the holder in mounting systems from other brands (SCOTTY®, RAM®, RAILBLAZA®, YakAttack®).
- To prolong the service life of the product, after using it in sea water, rinse it with plenty of fresh water.
