FTr300 - Transducer arm mount (L — 300 mm) for installation along the side of belly boat or kayak
Technical Details:
It has been designed for installation of the transducer at a distance of 300 mm from the mounting point on a kayak or belly boat (float tube). The design consists of the transducer mount with an M6*50 DIN 931 bolt and square knob nut that is joined to the tube Ø 22 mm, L — 250 mm, a male adapter shaped as a 12 pointed star and the tilt joint. The joint with the main splines is 27.7° and it’s equipped with 7.5° adapter washers, a spring and an M5*60 DIN 912 screw. The tilt position and rigidity of the joint is adjusted with a knob with the inserted M5 DIN 934 nut. The main parts are made of fiberglass-reinforced polyamide. The tube is made of anodized aluminium, fasteners — of A2 (AISI 304) stainless steel.
| Category: | Borika Fasten |
|---|
Product description:
- It is one of the most easy and compact models of the transducer arm mount, handy for mounting transducers on board of fishing kayaks and belly boats (float tubes).
- The fastening of the transducer is 90° rotated in relation to the mounting pad in order to enable the installation of the transducer along the side.
- It allows transducers (sonars) from Lowrance, Raymarine, Garmin and Humminbird and others to be installed at a distance of up to 30 cm from the mounting point.
- To secure the transducer use a 50 mm bolt, adjusted washers with small splines and a square knob nut.
- The design has a tilt spline joint that adjusts the position of the equipment in 7.5° increments. The knob nut allows the structure to be fixed in the raised position when the transducer is not in use.
- Can be easily fixed in any BORIKA FASTen® mounting system pre-installed on the transom (the FMb, FFr444 systems or Mb218 pad with the Fs218 mount are suitable).
- The tube that is the basis of the structure is made of anodized aluminium, which protects the metal against rusting and adverse environmental influences.
Materials: fiberglass-reinforced polyamide, anodized aluminium, A2 (AISI 304) stainless steel.
In the package: an FTr300 transducer arm mount.
Tips on using & installation:
- To prolong the service life of the product, after using it in sea water, rinse it with plenty of fresh water.
