FRh101 - Holder for Boat Electric Engine Arm Ø up to 50 mm
Technical Details:
Designed for supporting electric motor arms, the diameter of which is up to 50 mm. The assembly includes an Rh101 holder, an SBa038 adapter and an Fs223 T-Track adapter. The design of the holder consists of a body with an elastic clamp and external protrusions for its fixing, connected to the swivel-tilt adapter with an M6*40 DIN 912 screw and an M6 nut DIN 985, a tilt joint, complete with a spring and Dp230 washers with 7.5° splines, and a male adapter shaped as a 12 pointed star. The tilt position is fixed with a hex knob with an inserted M6 DIN 934 nut and an M6*55 DIN 933 bolt. The entire structure is fixed in the Fs223 mount and can be installed on boats equipped with a T-Track. The main parts are made of fiberglass-reinforced polyamide, the clamp, the gasket on the inner part of the body and the cover of the Ab038 ball are made of polyurethane. Fasteners — of A2 (AISI 304) stainless steel (except for the M6 DIN 934 brass nut).
| Category: | Borika Fasten |
|---|
Product description:
- Was designed for supporting arms of various electric motors (electric anchors) with a tube diameter of up to 50 mm.
- The structure can be mounted on the inner side T-Track of the boat; installation does not require additional tools and equipment.
- The bracket, in which the electric motor arm is intended to be secured, is covered with polyurethane inside, and can be adjusted in width. On the outer part there are elastic projections for fixing the elastic clamp.
- The bracket separately can be fully rotated around the axis. Also, the design provides a ball joint, which allows the holder to be 360 rotated around the ball and be fixed in the selected place by tightening the knob nut.
Materials: fiberglass-reinforced polyamide, polyurethane, A2 (AISI 304) stainless steel, brass.
In the package: an FRh101 holder.
Tips on using & installation:
- To install a system on a T-Track insert a T-bolt of the Fs223 mount, move it along it and fix it in the selected point by tightening the knob nut.
- To prolong the service life of the product, after using it in sea water, rinse it with plenty of fresh water.
